Introducing the Climax CM6200
Crane Bridge Repair
Journal Turning without removal using the Climax PL2000
The latest technology in large volume measurement and alignment using the Faro Laser Tracker.
This is a rotational gear that was measured for flatness. You receive a detailed report and graph showing exactly where the deviations in the gear are located and it can be milled to manufacturer specifications.
Journal Repair using the Climax PL4000.
Sennabogan 840 Excavator
Dipper boom bore repairs
For machining large flanges 73.5 – 199 inches (1866.9 – 5054.6 mm) in diameter, and featuring a center machine clearance designed to fit over 24 inches (609.6 mm) diameter kingpins, this Circular Mill can be configured for powerful milling, single-Point machining, and grinding operations.
Line Boring on all types of heavy equipment
View more photos of our work at https://www.flickr.com/photos/gingerhillindustrialservices
NEW EQUIPMENT - GANTRY MILL, LINEAR MILL.
This is the Climax LM6200 that can be used in both the linear and gantry configurations. This is the linear set up and is being used to cut key-ways right in the plant.
Tug Boat Stern Drive Tube Repair
Boring in Tight Places
OD Bore Welding
Climax FF6300 Flange Facing inside the Plant
Volvo A35D Bore repair of the center swivel yoke
In House Machine Shop
Climax PM6000 Large Portable Mill
Featured job - CAT 345 Excavator Rotational Gear Box Mount.
Map out the hole pattern, weld build up the holes, resurface the mount, drill and tap the mounting hole pattern, install the gear box, all on the side of the interstate highway.
Climax FF5000 Flange Facer
Automatic Bore Welding
Repairing the bores on the loader frame of a 345 CAT Excavator.
LM6200 Set up in the linear mode
MORE NEW EQUIPMENT!
Climax BB7100 Boring bar with huge machining range from 5 1/4" to 60". Plus the capability of making 2 cuts in 1 pass!
Add on the flange facing head that will travel 18" to 62 1/2"
Faro Laser Tracker
Climax CM6200 circular mill
Key Way Cutting
Automatic Bore Welder set to build up the ID of a bearing mount from an American Shredder.
Machining the bearing surface for the Rotary bearing under the house on a 5130 CAT Shovel
In Line Turning Machine cleaning up the outer surface of the shaft.
Climax PM2000 Small Portable Mill
192 inch boring bar used on dozer blade mounting bores.
Facing the end section of a Kelly bar used in the gas drilling industry.
Line Boring from 1 1/2" to 62"
Portable Key-way Milling
Flange Facing to 72"
Portable Mill 36"x 8" and 192"x 116"
Portable Lathes 1 1/2" to 24"
In Line Turning 3" to 10"
Pins and Bushings Fabricated and Installed
Weld Repair and Fabrication